z calibration/print issues
So I've been trying to calibrate my Z and got to -0.950 and still have holes but started to get what I think is the printer scratching the print but I could be wrong I printed the frog at -0.950 and that was the result is it all wonky because I was too low or too high? Also, I noticed I'm getting gaps in the same place every time and tried leveling the bed and that hasn't changed it either.
RE: z calibration/print issues
-0.935 did better but there is still gaps and the print still seems kind of off.
RE: z calibration/print issues
To me it looks like your printer has issues other than the z height. Its like its not extruding evenly or the extruder is loose or something. I would figure out what that is first before worrying about getting a perfect squish.
RE: z calibration/print issues
@neophyl
Do you have any idea of what problem it could be because everything seems fine but I'm not sure?