Benachrichtigungen
Alles löschen

Z axis motors not working in unison  

  RSS
Ivan
 Ivan
(@ivan-3)
Active Member
Z axis motors not working in unison

Hi,
Printer kit new out of the box, after assembly struggled to calibrate Z axis but somehow managed to calibrate after few failures. After printing two cute sample parts - the left Z actuator is not working properly. I switched the connection to the board between two Z’s, replaced the nut, checked the bearing rod - it’s straight, nothing helped. IMG_9642 IMG_9641

Veröffentlicht : 10/08/2021 5:24 pm
Dan Rogers
(@dan-rogers)
Noble Member
support

log into the e-shop with your serial # associated account, wait about ten seconds, and a agent chat becomes available.  That's where to get help with this.

 

Veröffentlicht : 11/08/2021 1:34 am
cwbullet
(@cwbullet)
Mitglied
tip

This might help - follow it carefully.  

--------------------
Chuck H
3D Printer Review Blog

Veröffentlicht : 11/08/2021 1:35 am
Teilen: