Yet another first layer dummy question
Hi all!
Trying to get a proper first layer tweaking around, and I was wondering: how smooth is it supposed to be at the end, and am I seeing early sign of going too far or something else?
The labels are the Z settings:
The plate starts from the bottom right.
I have a MK3s+. I use Ender filament, bed at 75˚C, extruder at 230˚C. The filament was in a dryer at 45˚C for a good 5--6h.
I was wondering if I should keep going until I make a mess of dangling PLA (window the operation), but the waving at the end (Z setting 1.02, 1.03): looks like stress relaxation. Am I right? Should I crank up the bed's temp before trying higher Z values?
Thanks!
RE: Yet another first layer dummy question
This is how I did 1st layer for the MK3S, still works on the C1L too
3rd digit applies to the MK3S
Core One L MMU3, MK3S