Notifications
Clear all
xyz cube calibration
Hello,
I have print an xyz cube calibration, and i think i have over-extrusion please see the pictures below. I am using the filament that is come with the printer. If i adjust the extrusion multiplier, do i need to adjust the Z calibration of the first layer also?
Thank you, kind regards,
Publié : 02/01/2021 9:02 am
RE: xyz cube calibration
Can't tell with that photo, but looks good to me.
--------------------
Chuck H
3D Printer Review Blog
Publié : 15/01/2021 11:27 pm