Notifications
Clear all

XYZ Calibration Failing  

  RSS
petersweeney1028
(@petersweeney1028)
Member
XYZ Calibration Failing

Hi All - I just finished assembling my printer and the self check passed. I am now getting stuck on XYZ calibration. I have read through a couple of blogs and articles about common errors but cant seem to get it to pass. 

I have adjusted the belt tensions for both Y and X axis. When I move the axises through the LCD menu they seem to move with no problem and I lubed up the bars. 

In the XYZ calibration settings I am showing a skew of .3

Any guidance would be appreciated 

Napsal : 07/09/2024 9:49 pm
Robin
(@robin)
Noble Member
RE: XYZ Calibration Failing

What does it say on the display when the error occurs? 

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Napsal : 12/09/2024 3:04 pm
Share: