Notifications
Clear all

Wizard Filament sensor error  

  RSS
John~T
(@johnt)
Eminent Member
Wizard Filament sensor error

Ran the wizard and it stopped with "Filament Sensor Error", yes I was careful with fastener torque.  Unplugged (checked orientation) and re inserted both ends of cable. Can I check sensor with my Fluke Multi Meter?   At a standstill right now.

Posted : 08/07/2019 4:29 pm
Dave Avery
(@dave-avery)
Honorable Member
RE: Wizard Filament sensor error

you can check under "support/sensors"

 

Posted : 08/07/2019 5:04 pm
Share: