Notifiche
Cancella tutti
What's the best way to clean a filament blow out in the hot end without damaging wires?
Bonus question: how'd this happen? This was under the sock 
Postato : 08/09/2020 7:15 am
RE: What's the best way to clean a filament blow out in the hot end without damaging wires?
Bonus question: how'd this happen? This was under the sock
Hello and welcome to the Prusaforum!
I strongly suspect that the area between the nozzle and the heatbreak was not sealed and therefore filament could escape from the side.
The nozzle-heatbreak area must seal and the nozzle must have a distance (gap) of approx. 0.5mm to the heating block (see figure).
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
Postato : 08/09/2020 9:59 am