Notifiche
Cancella tutti

What might cause third layer PETG tears?  

  RSS
nickdiaz
(@nickdiaz)
Active Member
What might cause third layer PETG tears?

What might cause the second or third layer to tear like the attached image?  Is this just an adhesion problem even though it didn't happen until after the first layer? 

This is my third PETG print. Previous PLA prints have gone great.  I re-ran calibration from scratch after my first PETG print.  PETG prints 1 and 2 went great - the second one was a 12 hour print that came out perfect.

Bed was washed with water and soap prior to the first of three PETG prints.  Bed was wiped with acetone between each PETG print.

Prusaslicer settings are fairly default for 15% speed, 15% infill. https://1drv.ms/u/s!AnmVeAiJeJq_hL5nUXX4fuO_pPpz3Q?e=dlIdJV

Questa discussione è stata modificata 5 years fa 3 tempo da nickdiaz
Postato : 18/05/2020 1:25 pm
Condividi: