Avisos
Vaciar todo
What kind of Printing Failure is this
Printed in PETG, standard Settings...
I assume, this is the starting/ending point on each layer...
How can I get rid of it. And if not, is there a way to turn them sowhere else?
Best Answer by jsw:
That's the seam where the device steps up to the next layer.
If your model will work with vase mode, it will eliminate it.
Otherwise, you can set the seam position in the slicer print settings.
Respondido : 05/12/2023 4:14 pm
RE: What kind of Printing Failure is this
That's the seam where the device steps up to the next layer.
If your model will work with vase mode, it will eliminate it.
Otherwise, you can set the seam position in the slicer print settings.
Respondido : 05/12/2023 4:24 pm