Notifications
Clear all
Upgraded from MK3 to MK3s now trouble
Long story short. I sat on my mk3s upgrade for over a year and decided I had some free time and did the install. Now I cant get good first layer. I have run the calibration over and over it comes out fine but prints do not. A lot of the time I get stringing or the skirt comes into the print. Here is the batman for reference
Opublikowany : 06/03/2023 4:03 am
Your first picture shows fingerprints and other smears on the build sheet. A thorough clean might make a big difference.
Cheerio,
Opublikowany : 06/03/2023 4:01 pm