Trying to print a hero

Dernier message

RSS

jason-3

(@jason-3)

New Member

Trying to print a hero

Hello. I was able to print a few small things such as the Whistle and Batman logo. However, after trying to print Hero1 for a friend, it turned out very strange. I used PrsuaSlicer 2.0 with the 0.007mm ULTRADETAIL MK3 setting.

Publié : 18/02/2020 11:25 am

Statistiques du forum

559 Forums

62.8 K Sujets

442.4 K Messages

18 En-ligne

67.4 K Membres

Le dernier des messages: Can High Flow Nozzle be used on MK4 Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé