Notifiche
Cancella tutti
The object isn't fixed
after about 30min printing the object starts to "walk away" - so the object isn't fixed.
Are there some ideas for what I have to do?
Thx for help - this isn't that what I have looked for....
Postato : 27/10/2022 3:48 pm
Is this a new printer?
This sounds like a first-layer issue.
Please run a first layer Z calibration and show us the print *on the print sheet*. A picture of a typical failed print might be useful as well.
Cheerio,
Postato : 27/10/2022 4:37 pm
Razor hanno apprezzato