Super Pinda broken?
Hello,
prusa i3 MK3s+
Ran g80 in Pronterface. Then g81.
Results greater than .2?
What should I do?
Z axis calibration hit everytime super pinda was raised even a bit, any lowering and I had z corrections around 3mm in first layer calibration
Thank you
RE: Super Pinda broken?
Also how do I contact Prusa support.
Preferably a phone number
RE: Super Pinda broken?
@oliver-printer
Hello and welcome to the Prusaforum!
I don't quite understand the first question, and I can see almost nothing in the picture.
The best way is to contact Prusa via chat. Log in with your account at Prusa and select the eshop. After a few seconds, the chat window appears in the lower right corner. Deactivate adblocker. If the chat window does not open, try to change the browser (google chrome).
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Super Pinda broken?
@oliver-printer
Can you confirm the sensor is working? Does a light come on if you put a tool just belwo the sensor?
--------------------
Chuck H
3D Printer Review Blog