Notifications
Clear all

stripped nut trap in RAMBo-cover-base  

  RSS
MarkR
(@markr)
New Member
stripped nut trap in RAMBo-cover-base

I managed to make it through to the last assembly step and then stripped the nut trap as I was trying to seat one of the M3n nuts that hold the EINSY in the csae. I'm thinking of just cutting that one out and mounting with 3 screws until I can print a new case. Thoughts? The M3x10 / nut combo is firmly wedged, and I can't get a grip on the nut to break it free.

Posted : 24/09/2018 4:03 am
rufflez
(@rufflez)
Estimable Member
Re: stripped nut trap in RAMBo-cover-base

3/4 will be fine for printing. Its not mission critical to have all 4. Print a new case when you get it up and running and replace it when you have free time.

Posted : 24/09/2018 5:52 am
Share: