Notifications
Clear all
Strange shifting behavior--any ideas?
This is happening printing ABS on my mk3s, and has happened a couple of times in exactly this way--with a layer shift very near to the beginning of the print. I might have thought the model was shifting on the bed, but that's not it because I printed 3 parts at the same time and they all show this behavior.
I have no problems with PLA. Is it possible it's something specific to ABS/these prints, or am I looking at a belt issue?
Many thanks,
Joe
Publié : 11/09/2020 8:23 pm
RE: Strange shifting behavior--any ideas?
are you getting any crashes?
Have a look at the LCD menu
if this happens again
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Publié : 12/09/2020 4:53 pm