Slot for the Extruder Heater cable is upside down
Hello,
so I noticed that the slot for the extruder heater cable is upside down and I´m unable to put it in bc there are cables blocking it. Is there a way to turn it the right way? Also attaching a photo, thank you for your help!
Best Answer by JoanTabb:
Hi,
If you grasp the left hand side of the plastic shroud with a pair of needle nosed pliers, the cover should come off, turn it round and push back on.
regards Joan
RE: Slot for the Extruder Heater cable is upside down
Hi,
If you grasp the left hand side of the plastic shroud with a pair of needle nosed pliers, the cover should come off, turn it round and push back on.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK