Slanted prints
After upgrading to the mmu2s and updating to the latest firmware (3.7.2), all my prints are now slanted on the y axis.
This is confusing as the y axis was not touched during the upgrade
I've printed a few different models and all are slanted.
I printed the 20mm calibration cube twice and both came out slanted, but identical. This makes me rule out belt issues as this wouldn't cause such consistent errors.
Attached a photo of one of the cubes. (Can't find both atm)
Any ideas of what this could be?
RE: Slanted prints
Just throwing out ideas: but bent Z rods, warped frame, debris on the Y belt drive gear, debris in the Y belt teeth, bent Y motor shaft, over stretched belt...
Reslice, but move where the cube is printed and see if the slope is consistent at the front and rear of the bed. It'd help rule out causes.
RE: Slanted prints
[...] Any ideas of what this could be?
Attachment removed
Uhm... that looks like 2 dudes ignoring each other at a burger bar.
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan