rough sidewalls

Dernier message

RSS

SFilipp

(@sfilipp)

New Member

rough sidewalls

Hi!

since recently I am experiencing rough sidewalls on my prints. Does anybody know what could be the reason for the randomly distributed defects in the layers?

Any help on how to eliminate these defects is much appreciated!

Thanks!

Publié : 08/09/2022 7:22 pm

Diem

(@diem)

Illustrious Member

Quite a lot of that is likely to be the effect of damp filament. There are signs you may have belt tension issues but dry your filament and try again; show us the results if they remain unsatisfactory.

Cheerio,

Publié : 08/09/2022 11:56 pm

SFilipp

(@sfilipp)

New Member

Topic starter answered:

RE: rough sidewalls

Thanks! Drying the filament really has indeed helped.

Best,

Publié : 10/09/2022 3:02 pm

Statistiques du forum

559 Forums

62.7 K Sujets

441.9 K Messages

21 En-ligne

67.2 K Membres

Le dernier des messages: Browsing / Navigating files on USB-drive unusable slow and laggy Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé