Notifications
Clear all
Repeated banding in vertical print
I recently completed assembly of my MK3S+. Up until the print shown I had mainly printed smaller parts that have come out well. This one exhibits what I have seen called z banding. I have read conflicting information that this could be due to z-axis issues rod or lead screw issues. Any advice or recommendations for where to start troubleshooting would be appreciated.
Posted : 26/12/2021 9:10 pm
Topic starter
answered:
RE: Repeated banding in vertical print
I tightened everything up and adjusted the pulley on the y-axis. It looks like it could have been rubbing. Printing well now.
Posted : 28/12/2021 5:11 pm