Notifications
Clear all
problem prusa logo print
Hi,
i assembled a new mk3s and ran all tests successfully. Also first layer test and adjusting z was fine. When i try to print the prusa logo which came with the sd-card, the head goes all the way to the right of the x-axis and produce a crash. What can be the reason for this happening?
regards, Thomas
Posted : 16/09/2019 2:31 pm
RE: problem prusa logo print
Have you tried any of the other pre-sliced gcode files? The batman logo perhaps? If you continue to have problems, log into the e-store and contact support via the online chat button.
Posted : 16/09/2019 5:19 pm
Topic starter
answered:
RE: problem prusa logo print
not yet, but will try by end of week (out for work...grr).
regards, Thomas
Posted : 16/09/2019 5:59 pm