Notifications
Clear all
Printer doesn’t move XY for first layer calibration
I just installed a new heater block and the MMU2S. Now when I try to run the first layer calibration it does not move in the XY direction and simply extrudes a massive Hershey’s kiss on the bed. How can I fix this?
It has worked fine for weeks without the MMUR2S and the new solid copper heater block but since I install that I can’t get it to work.
Best Answer by Muttzy:
Must be sleepy - missed the IR sensor calibration step.
Publié : 10/06/2022 5:04 am
Topic starter
answered:
RE: Printer doesn’t move XY for first layer calibration
It will mesh bed level but when it starts extruding for the first layer does not move.
Publié : 10/06/2022 5:19 am
Topic starter
answered:
RE: Printer doesn’t move XY for first layer calibration
Must be sleepy - missed the IR sensor calibration step.
Publié : 10/06/2022 6:39 am