Notifications
Clear all
Print differences in x Direction
Hi Everybody,
with my Mk3s there are differences in the print in the layer (see picture). What could be the reason for this?
Best regards
Toni
Opublikowany : 29/11/2024 3:35 pm
RE: Print differences in x Direction
messed up bed level correction, degraded coating on PEI, greasy or dirty PEI, gravitational anomaly
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Opublikowany : 29/11/2024 5:04 pm