Benachrichtigungen
Alles löschen
Pinda catching filament
I have just started to use a powder coated sheet. With the steel sheet the live z adjust was set to -1.7 and the first layer test square was perfect. I did the First layer calibration then printed a calibration square. To get a clean first layer I have the live adjust set to -2.o and the live adjust might be lower still. However the Pinda probe is now catching on the filament. Should I raise the pinda probe one click and rerun first layer calibration or try something else.
Veröffentlicht : 04/12/2019 6:17 pm