Noticable line in printed part with outer shells

Dernier message

RSS

Yngeinstn

(@yngeinstn)

Eminent Member

Noticable line in printed part with outer shells

I am trying to print this part and I am seeing a very noticeable line at the point the layer changes from the bottom layers to the construction of the walls. In fact i am seeing this artifact in most prints that have shell like design.

Any suggestions on how to fix this would be greatly appreciated

Publié : 17/02/2021 12:29 pm

Neophyl

(@neophyl)

Illustrious Member

RE: Noticable line in printed part with outer shells

Please read https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/fatter-walls-at-around-layers-between-support-and-overhang/#post-369868

or https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/artifact-help/#post-371782 posted just 4 days ago.

Publié : 17/02/2021 2:44 pm

Statistiques du forum

559 Forums

62.9 K Sujets

442.8 K Messages

19 En-ligne

67.6 K Membres

Le dernier des messages: Some perimeters starting from the overhang / bridge Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé