Notifications
Clear all

Newbie having first print issues.  

  RSS
jlc1978
(@jlc1978)
Active Member
Newbie having first print issues.

Did the calibrations, tried first print and it is a mess.  The extruder dragged the printed filament around and I finally stopped the print.  I used  brand new PETG and the textured plate.The print was the PRUSA logo.  Any suggestions greatly appreciated.

Publié : 09/02/2024 4:02 pm
jlc1978
(@jlc1978)
Active Member
Topic starter answered:
RE: Newbie having first print issues.

Fixed it - finer calibration to -1870 and clean bed well. 

Publié : 10/02/2024 8:19 pm
Partager :