Notifications
Clear all

New Kit won't Run thru Self Test  

  RSS
Sam
 Sam
(@sam-14)
Active Member
New Kit won't Run thru Self Test

I have built a new MK3 and cannot get it to get past the Self Test . I get an error for the heater/thermistor is not connected. We have been online with Prusa support and have tried everything including replace thermistor, heater cartridge and einsy board. It will not send power to the hotend or bed even if we bypass the Self Test and go to the temperture page.

Posted : 10/04/2018 6:29 pm
Share: