Notifications
Clear all
MK3S+ PTFE tube trimming
I hate to be a pain but I have yet another question about my new MK3S+. The assembly manual referenced the length requirements for the PTFE tube in the extruder assembly and I'm a little concerned that I never looked at the article or did any trimming. Could this have anything to do with under-extrusion? Do I need to disassemble the extruder and trim?
Thanks in advance for any advice.
Publié : 13/08/2021 12:57 am
PTFE
Did you use the one provided? It should be the right length.
--------------------
Chuck H
3D Printer Review Blog
Publié : 13/08/2021 1:02 am
Topic starter
answered:
PTFE
I used whatever was provided and didn't have anything to cut. It was probably already attached to the hotend.
Publié : 13/08/2021 10:37 am