Notifiche
Cancella tutti
Mk3 Y carriage with MK2 Heatbed
Hi team,
Need a help and suggestions. I am building a new prusa i3 Mk3 but I wrongly purchased MK2 Heatbed bed which don't fit and alignment of hole is few millimetres differs. Not sure how to mount. Any suggestions welcome
Postato : 21/04/2020 5:55 pm
RE: Mk3 Y carriage with MK2 Heatbed
I did it the other way,
I made some printed slatts with holes for the Mk2, Y axis positions, and holes for the Mk3 heatbed to hold a 24 volt Mk3 heatbed onto a mk2 frame.
however I would much prefer a mk3 (Mk52, 24volt) heatbed, with removeable buildplate
regards Joan
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Postato : 21/04/2020 7:01 pm