Notifications
Clear all
Mesh Bed Leveling Problems
Hello,
I'm desperate, I've been trying the leveling for days, the pressure is getting better, but now it prints on the right side so strange. See photos.
My values are :
Left: 14
Right: 2
Front: 14
Rear : 10
And Z stands at : -1.250
What can I do better ?
Posted : 17/04/2021 8:14 am
RE: Mesh Bed Leveling Problems
You are close but a little bit too low, too squished.
Your current value would probably print smaller objects OK but those with a very small base area and taller prints might fail.
Back off until those surface ripples *just* disappear and you will OK.
If you have not done so enable 7x7 mesh-bed levelling.
Cheerio,
Posted : 17/04/2021 5:16 pm