Notifications
Clear all
Looping?
So I'm looking to print a couple of very small items.
I changed my MK3S over to a 0.25mm nozzle.
I just can't seem to get past this issue of the filament (PETG) creating loops on the first pass. (pic attached)
My Z Axis is now at 0.00.
Never had an issue like this with the 0.4mm.
I changed PrusaSlicer to slice spec using the new 0.25mm nozzle
XYZ calibration seems to be fine
I've tested hotter Nozzle, adjusted Z down to 0, slowed speed from 100% to as low as 50%
still nothing but loops....
Advice anyone?
Publié : 28/01/2025 9:43 pm