Avisos
Vaciar todo
Just finished resetting EVERYTHING back to prusa defaullts - and now this?!?!?
Ok, I now have a new hotend and have done a firmware reset. Also, I have set all the slicer settngs back to prusa's PETG default settings again, and now I'm getting this "hole"
Any ideas???
Respondido : 23/11/2020 5:01 am
RE: Just finished resetting EVERYTHING back to prusa defaullts - and now this?!?!?
Try again. I have never seen that before. It might be a one off.
--------------------
Chuck H
3D Printer Review Blog
Respondido : 23/11/2020 1:00 pm
RE: Just finished resetting EVERYTHING back to prusa defaullts - and now this?!?!?
Was the prow of the benchy facing the back of the printer by any chance ?
Respondido : 23/11/2020 1:07 pm
RE: Just finished resetting EVERYTHING back to prusa defaullts - and now this?!?!?
I think it's due to a bad fan duct (bad cooling). Why not try a fan duct of a different design?
https://www.thingiverse.com/rh_dreambox/designs
Bear MK3 with Bondtech extruder
Respondido : 23/11/2020 3:38 pm