Notifications
Clear all
just assembled, applied power, but nothing - no lcd screen, only green power light on einsy board, unable to upload firmware
I tried to power up after assembly, and can't upload firmware. I get "could not open com port 3" or "timeout" errors.
All fuses good, 24 volts applied to bottom of einsy board.
Help?
Greg
Publié : 10/09/2019 12:29 am
RE: just assembled, applied power, but nothing - no lcd screen, only green power light on einsy board, unable to upload firmware
Go to the EShop and open a chat window.
Prusa support can step you through troubleshooting.
Publié : 10/09/2019 5:45 am