I would like to raise the level of the intro line

Dernier message

RSS

kyle k

(@kyle-k)

Membre

I would like to raise the level of the intro line

I was just curious what the easiest way would be to slightly raise the height of the intro line so it does not squish filament onto the top of the nozzle?

I have an mk3s.

Publié : 07/12/2023 2:56 pm

Rocket printer

(@rocket-printer)

Active Member

RE: I would like to raise the level of the intro line

Hi Kyle,

The way to do that would be to redo first layer calibration or you could adjust it in Prusa slicer.

Regards,

Rocket Printer

Publié : 04/01/2024 7:17 pm

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

19 En-ligne

67.7 K Membres

Le dernier des messages: Leak at nozzle Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé