Notifications
Clear all
Hotend bottom and nozzle dirty
Hi there,
I have had several cases, when trying out different filaments and switching beds, that the print got loose and started to move around, with as a result a huge blob of filament stuck to the nozzle en bottom of the hotend. I tried to clean that out but still... When you look at the pictures below, is this a "normal" looking hotend and nozzle ?
Posted : 21/05/2020 5:02 pm
RE: Hotend bottom and nozzle dirty
A lot of people have this problem when they get a Blob of Doom...
If you use a Brass Wire Brush on the hot, hotend, this should mostly sweep away!
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK