Notifiche
Cancella tutti
Get issues with all axis on calibration
After being forced to dissassemble the extruder after a bad unload causing a clog, I get issues with all my axis. X axis looks and sounds perfectly fine, Y and Z have not been altered and should be working without any problems.
When doing XYZ calibration, it fails either on X axis (Check X axis length) Y axis (Check Y axis pulley) Z axis (Pinda probe not working)
Both X and Y have successes from time to time, I have checked the individual errors on them aswell, but they are good.
Z axis on the other hand jam the nozzle into the printbed, and the probe don't recogize the bed with or without steel sheet. However, if I hold my pliers below it the light goes of and it is working as intended.
I have also updated to the new software
Please help!
Questa discussione è stata modificata 4 years fa da Kokort2
Postato : 30/11/2020 7:48 am