Notifications
Clear all
First time user.My boat has failed twice! Help!
Publié : 03/04/2022 7:59 pm
Topic starter
answered:
RE: First time user.My boat has failed twice! Help!
Sorry, getting used to this interface. The first print is on the left, the second on the right. The prints look great and then it looks like they lose adhesion. I recalibrated Z after the first time it happened and thought I had it kicked. Prusa PLA Grey 1.75mm filament
Publié : 03/04/2022 8:10 pm
RE: First time user.My boat has failed twice! Help!
Welcome to the forum. Please post a picture of the bottom on the most recent benchy.
Mk3S+,SL1S
Publié : 03/04/2022 8:17 pm
Topic starter
answered:
RE: First time user.My boat has failed twice! Help!
As requested, first and second prints
Publié : 03/04/2022 8:43 pm
RE:
Thanks for the pix. Your first layer calibration is not quite where it needs to be. It is putting your nozzle too high. You are not getting enough squish against the bed which causes poor adhesion. The following picture is what you are aiming for. Notice how the lines of fill snug up to the perimeters.
Mk3S+,SL1S
Publié : 03/04/2022 8:55 pm