Notifications
Clear all
First print quality feedback
Looking for some tips on my first print.
Seems, that for some reason the result is passable but not very accurate. For example, based on references I would expect the print on top of the back legs to be more elliptical instead of wiggly. What could cause this?
Also looking for feedback on the bottom finish, if it should look like this or smoother.
Posted : 03/05/2021 11:37 am
RE: First print quality feedback
First layer looks a little off. Lower your Z until the bottom is smooth and not able to easily see any lines.
Posted : 03/05/2021 8:33 pm
RE: First print quality feedback
@dan-rogers
Concur. Looks a little high.
--------------------
Chuck H
3D Printer Review Blog
Posted : 07/05/2021 3:55 pm