Notifications
Clear all
first layer small size
Good morning. I'm printing a 40x40 cube and in prusa slicer the first layer is smaller than the other layers. why? there is a function to make the first layer the same as the others.
Opublikowany : 27/03/2020 4:49 pm
RE: first layer small size
Hello Stefano,
i had the same problem and was happy to find this question in the form.
Unfortunatly no one answered yet 😌 😔 🙁
Here is what i found:
You have to set the "elephant foot correction" to 0mm
https://help.prusa3d.com/en/article/elephant-foot-compensation_114487
Opublikowany : 01/01/2021 8:14 pm
Tracy polubić