Avisos
Vaciar todo
First layer showing lines in some parts
Hi, since upgrading my MK3S to MK3S+ one of them shows lines in the first layer - but only in some parts of the bed. I have already tried loosening and slightly retightening the printbed-screws and also using the Meshbed-Level-Adjustment. Attached is a picture of an in the front perfect and in the back really sh*tty first layer.
Thank you all in advance!
Respondido : 20/01/2023 9:27 pm
RE:
Even the front could go a little lower.
Cheerio,
Respondido : 20/01/2023 9:29 pm