Notifications
Clear all
first layer problems
Whilst doing a first layer calibration.
Nozzle leakage of filament resulting in a blob, although the
calibration test appears ok.
Then when attempting a simple PLA print such as a bottle opener or a temperature tower, the first layer breaks up immediately.
Any ideas please
Publié : 26/10/2020 6:52 pm
RE: first layer problems
Pictures?
Picture first layer?
Clean bed with dish soap, only dish soap.
The make a 100% first layer, this is very important.
The 2 settings above are very important for printing, and need to be 100%.
How to do a first layer,
Publié : 27/10/2020 8:40 am
Topic starter
answered:
RE: first layer problems
@peter-m26
thanks so much for such a speedy response. I shall work on it and respond later. Again thank-you
Publié : 27/10/2020 10:07 am