Clear all

First layer problem with loose "strings"  

Page 2 / 2
Trusted Member
Topic starter answered:
RE: First layer problem with loose "strings"

I'll make experience by make more prints then I'll see how it works best. Of course I'll make some decision based on your replys since you're more experienced than me now. Based on how the surface looks ill wipe with IPA. I mean, if I see some spot from last print (there where print-object stood).

Also its far fewer work just clean with IPA than walk accross the office with bed. 😉

Posted : 10/11/2020 12:19 pm
Page 2 / 2