Notifications
Clear all
First layer issues
Opublikowany : 23/02/2022 4:02 am
Topic starter
answered:
RE: First layer issues
Hoping someone can help me out. My prints are coming out like this more often than normal lately. It sees as if the filament is going over a small bump and throws my print off causing chaos. I clean the bed sheet with dawn soap after each use. Sometimes prints will start off like my last 2 photos and will complete, but without a nice looking first layer. Its hard to tell if my offset is too close or not because when I remove the mess from a failed print, The middle seems to come off easy while the parts near the edge have more adhesion. What are your opinions and tips? I've seen some wonderful first layers by some pros and would love to get closer to what they have. Thanks for the help.
Opublikowany : 23/02/2022 4:18 am