Notifications
Clear all
First layer issue. Can someone help me understand what I am looking at?
So my Prusa has been running beautifully until I went and fiddled with the calibration wizard.
Now I am running into a first lay problem and don’t know how to diagnose it - not sure if my Z is too low or too high.
Based on the photos, could someone give me some guidance? Current Z offset is -1.500mm.
Napsal : 22/01/2023 12:22 am
Your first layer\z calibration is a little low, too much squish.
Your print-sheet needs cleaning. Clean the sheet with dishwashing detergent (Dawn/Fairy) and plenty of HOT water, rinse well and dry with a fresh paper towel. Handle by the edges only.
Cheerio,
Napsal : 22/01/2023 2:05 am
Echo2112 se líbí