Notifications
Clear all
First layer fine... 2nd and 3rd not so much
Hey guys. Trying to get my printer set up calibration went fine and test came out well.
Printed the prusa logo and first layer went down f8ne however there has been some issues.
Can anyone help??
Im using prusament at 75% speed. This is the prusa logo whoch is already loaded onto the sd card.
Any help it much appreciated.
Napsal : 19/01/2019 3:22 pm
Topic starter
answered:
Re: First layer fine... 2nd and 3rd not so much
for anyone looking to know i hadnt bolted the filament door closed. the little gear wasnt making contact with the filament so it was a feeed issue.
Napsal : 19/01/2019 4:11 pm
Re: First layer fine... 2nd and 3rd not so much
you won't forget again!
😀
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Napsal : 19/01/2019 4:13 pm