First Layer Comparison - Speed vs Quality

Dernier message

RSS

nathandmelton

(@nathandmelton)

New Member

First Layer Comparison - Speed vs Quality

Greetings,

I noticed some variation in the first layer quality when switching between 0.20mm SPEED and 0.20mm QUALITY using Prusa slicer. The SPEED option was actually better. All other settings and conditions were the same (bed prep, material, etc.). I'm just curious what settings between 0.20mm Speed and 0.20mm Quality may have made this difference. See attached pdf image.

Any help is most appreciated.

Speed vs Quality 21.12.30

Thanks!

Publié : 30/12/2021 6:49 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

20 En-ligne

68.1 K Membres

Le dernier des messages: Revo Six on MK3S+ has extra stringing and oozing Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé