Notifications
Clear all
First layer calibration, trouble interpreting results
Publié : 25/09/2024 11:42 am
RE: First layer calibration, trouble interpreting results
way to high.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Publié : 27/09/2024 3:15 pm
Brian a aimé
RE: First layer calibration, trouble interpreting results
Agreed too high, not enough squish. At the end of the calibration you are aiming to print a single layer postage stamp sized *sheet*. It should be possible to peel it off in one and fold it without the threads seperating. If it breaks into lines it is too high, not squished enough. If it is a single sheet but with wavy lines or drag marks on it you are too low.
Cheerio,
Publié : 27/09/2024 5:45 pm