First layer calibration question
Hi ppl 🙂
Quick question, when doing first layer calibration, is the line suppose to be so thin ? I can't really see how the filament look, just like you see in the prusa startup video. 🙂
Best Answer by floh:
The zigzag lines is really thin, this is fine. Its important that the square is clean and flat.
I suggest you doing further with z-calibration by doing live adjust:
https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/
Have a lot of fun!
Floh
RE: First layer calibration question
The zigzag lines is really thin, this is fine. Its important that the square is clean and flat.
I suggest you doing further with z-calibration by doing live adjust:
https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/
Have a lot of fun!
Floh
RE: First layer calibration question
@floh
Thanks alot, i will try this today. 🙂