Notifications
Clear all
First few print problem
I wonder if any can help me out please. The prints seem to be ok apart from these corners.
Does anyone have any ideas please
Posted : 25/05/2019 12:45 pm
RE: First few print problem
Hard to tell from the picture but that looks like a normal seam where the layers start/finish. Theres various options in the slicer (nearest, random, aligned , rear) that can alter where the seams are located but its normal and something you have to live with unless your model geometry can hide them.
Posted : 25/05/2019 3:00 pm
Mickfb liked
Topic starter
answered:
RE: First few print problem
Thanks for the reply neophyl. Found that the aligned to be the best solution.
Posted : 26/05/2019 7:33 pm