Notifiche
Cancella tutti
First Calibration error
When I run the tests through the wizard. Every time I get to the calibration of the nozzle, it hits the base. Do I need to tighten the nozzle tighter?
Postato : 21/10/2022 10:01 pm
RE: First Calibration error
New printer? Self assembled? Old printer? Messed up printer?
I try to give answers to the best of my ability, but I am not a 3D printing pro by any means, and anything you do you do at your own risk. BTW: I have no food for…
Postato : 21/10/2022 10:50 pm
ccook79 hanno apprezzato
RE:
Do not tighten the nozzle, you will most probably damage your hot end.
Check the above video, and this article: https://help.prusa3d.com/article/xyz-calibration-mk3-mk3s-mk3s_112351
And check the correct mounting of your PNDA.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Postato : 22/10/2022 3:19 pm
ccook79 hanno apprezzato