Notifiche
Cancella tutti
First benchy after MK3S+ assembly. Any tips?
Hi all,
this is my first benchy printed straight from the gcode that came on the SD card.
I am not sure why the layers don’t look uniform. Any ideas on what I can adjust/tune to get better looking layers?
I can get better looking prints out of my mini currently and I imagine the MK3S+ could put out better prints.
Thanks!
Postato : 14/11/2021 5:10 pm
RE: First benchy after MK3S+ assembly. Any tips?
Duplicate ...
Postato : 15/11/2021 5:22 am